Home |
Map |
Projects |
Construction |
Soldering |
Study |
Components |
555 |
Symbols |
FAQ |
Links
Tools required for electronics
Also see: Starter kit | Workbench |
Soldering guide
Rapid Electronics
stock a wide range of tools and they have kindly allowed me to use their photographs
on this page.
Soldering iron
For electronics work the best type is one powered by mains electricity (230V in the UK),
it should have a heatproof cable for safety.
The iron's power rating should be 15 to 25W and it should be fitted with a small bit of 2 to 3mm diameter.
Photograph © Rapid Electronics
Other types of soldering iron
Low voltage soldering irons are available, but their extra
safety is undermined if you have a mains lead to their power supply!
Temperature controlled irons are excellent for frequent use, but not worth the extra
expense if you are a beginner. Gas-powered irons are designed for use where no mains
supply is available and are not suitable for everyday use. Pistol shaped solder guns
are far too powerful and cumbersome for normal electronics use.
Soldering iron stand
You must have a safe place to put the iron when you are not holding it.
The stand should include a sponge which can be dampened for cleaning the tip of the iron.
Photograph © Rapid Electronics
Desoldering pump (solder sucker)
A tool for removing solder when desoldering a joint to correct a mistake or replace a component.
Photograph © Rapid Electronics
Solder remover wick (copper braid)
This is an alternative to the desoldering pump shown above.
Photograph © Rapid Electronics
Reel of solder
The best size for electronics is 22swg (swg = standard wire gauge).
Photograph © Rapid Electronics
Side cutters
For trimming component leads close to the circuit board.
Photograph © Rapid Electronics
Wire strippers
Most designs include a cutter as well, but they are not suitable for trimming component leads.
Photograph © Rapid Electronics
Small pliers
Usually called 'snipe nose' pliers, these are for bending component leads etc.
If you put a strong rubber band across the handles the pliers make a convenient holder for
parts such as switches while you solder the contacts.
Photograph © Rapid Electronics
Small flat-blade screwdriver
For scraping away excess flux and dirt between tracks, as well as driving screws!
Photograph © Rapid Electronics
Heat sink
You can buy a special tool, but a standard crocodile clip works just as well and is cheaper.
Photograph © Rapid Electronics
The following tool is only required if you are using stripboard:
Track cutter
A 3mm drill bit can be used instead, in fact the tool is usually just a 3mm drill bit
with a proper handle fitted.
Photograph © Rapid Electronics
The following tools are only required if you make your own PCBs:
PCB rubber
This is an abrasive rubber for cleaning PCBs. It can also be used to clean stripboard
where the copper tracks have become dull and tarnished.
Photograph © Rapid Electronics
Small electric drill
Ideally this should be mounted in a drill stand. You will need a range of small drill
bits, but for most holes a 1mm bit is suitable. Larger holes can be drilled with a hand drill
but 1mm bits are too fragile to use reliably in a hand drill.
Photograph © Rapid Electronics
Rapid Electronics
stock a wide range of tools and they have kindly allowed me to use their photographs
on this page. We buy most of our tools and components for the Electronics Club from
Rapid Electronics. The photographs are from their Image Gallery CD-ROM.
© VCampus 2013, The Electronics Club,
vcampus.co
